Printing in parts
I printed the model in separate parts on a Bambu Lab A1, with approximately 300 hours of printing in total.
Printing · Assembly · Photography
85 cm Gundam Build
An 85 cm 3D-printed model: approximately 300 hours of printing, plus about a day of sanding and assembly.
Location
Vancouver, BC
Date / status
Completed
Category
3D printing
My contribution
3D printing · Sanding · Assembly · Photography
85cm
Approx. finished height
300h
Approx. total print time
+1day
Approx. sanding & assembly time
Project note
This 85 cm build was printed in separate parts on a Bambu Lab A1 using blue, red, yellow, black, white, and gray filament. Printing took approximately 300 hours, followed by about one additional day for finishing and assembly. I completed the printing, sanding, assembly, and photography.
Model file purchased from a third-party marketplace. Original design rights remain with the respective rights holder. Tracefold Studio does not publish, share, provide downloads of, or resell the file.Finishing & assembly
I used blue, red, yellow, black, white and gray filament, then spent about one additional day sanding and assembling the parts.
The finished model
The finished model stands approximately 85 cm tall. I completed the printing, sanding, assembly and photography.
An evolving record
A closer look is on its way.
Keep exploring
Explore the print archive